Harley Davidson Handlebars Loose

Manual says to remove the inner fairing to get at the handle bar clamp screws.

Harley davidson handlebars loose. Remove the fork lock trim piece by just prying off to get access to 2 phillips screws. Bob LaRosa and Mark DiPietro start this project that focuses on removing Harley handlebars. Remove the center trim piece over the headlight housing by removing the speed screw on front and loosening the screw in back.

If the bars have too much movement for you likings you can replace the rubber bushing with either polyurethane or. Have the pure satisfaction of working on your own Harley. Road Glide Tallboy Handlebar - 55800551A Harley-Davidson USA This 125 diameter bar features an optimized ergonomic design for taller and long-limbed riders.

Trick your Harley out the way you want it. The magic component of our Sony Plug Play Bundles that maintains handlebar controls is the AXXESS Integrate ASWC-1 handlebar control module pictured below. With little effort I can wiggle the hand grips back and forth about an inch.

Do it in your garage or on your patio right on the kickstand. Just torque in a front to back pattern until they feel very secure. The published torque values are likely specs for new clamps and new bars ie.

And Adjust the Handlebar. If you like the results there will be enough of that 25-pound bag of shot left to do a few more bars. Save up to 75 off Top Gear.

This will give you access to the bolts holding the handlebars. Loose these two screws and adjust the handle bar to your comfort position. Part Ii of IiThe Shovelhead.